DF22001YiQi.git

			@@ -2283,7 +2283,7 @@
			}
			else if (logMiddle.WorkingProcedure == "OP10")
			{
			if (logMiddle.QualityState != (int)QualityState.OK)
			if (logMiddle.QualityState == (int)QualityState.NG)
			{
			qualityNoOkEnum = QualityNoOkEnum.OP10厚度超差;
			}
			@@ -2291,7 +2291,7 @@
			}
			else if (logMiddle.WorkingProcedure == "OP20")
			{
			if (logMiddle.QualityState != (int)QualityState.OK)
			if (logMiddle.QualityState == (int)QualityState.NG)
			{
			qualityNoOkEnum = QualityNoOkEnum.OP20小头孔直径超差;
			}
			@@ -2299,7 +2299,7 @@
			}
			else if (logMiddle.WorkingProcedure == "OP35")
			{
			if (logMiddle.QualityState != (int)QualityState.OK)
			if (logMiddle.QualityState == (int)QualityState.NG)
			{
			qualityNoOkEnum = QualityNoOkEnum.OP35滚压力不合格;
			}
			@@ -2307,7 +2307,7 @@
			}
			else if (logMiddle.WorkingProcedure == "OP40")
			{
			if (logMiddle.QualityState != (int)QualityState.OK)
			if (logMiddle.QualityState == (int)QualityState.NG)
			{
			qualityNoOkEnum = QualityNoOkEnum.OP40厚度超差;
			}

			@@ -79,8 +79,11 @@
			WorkingProcedure = "OP30",
			WorkPieceID = "DZ045L2406240103521TAS",
			UpdatedTime = DateTime.Now,
			QualityState = (int)QualityState.NG,
			QualityNoOk=(int)QualityNoOkEnum.OP30涨断工位力矩大,
			QualityNoOkReason= QualityNoOkEnum.OP30涨断工位力矩大.ToString(),
			MonitoringPoint = "",
			QualityStateStr="OK"
			QualityStateStr="NG"
			}
			;
			string WorkingProcedure = logMiddle.WorkingProcedure;

	DataCapture/iWare_SCADA_DataCapture/iWare_SCADA_BusinessLogical/BLL/WorkPieceInfoManager.cs	8 ●●●●● 补丁 \| 查看 \| 原始文档 \| blame \| 历史
	DataCapture/iWare_SCADA_DataCapture/iWare_SCADA_Test/UnitTest1.cs	5 ●●●●● 补丁 \| 查看 \| 原始文档 \| blame \| 历史